Invoke this command for disaster recovery only. WARNING: all existing data in all partitions on Flash will be lost! Do you wish to continue? y/n: [n]: y
Smart Init is enabled smart init is sizing iomem ID MEMORY_REQ TYPE 000091 0X00092280 C2600 single Ethernet 0X000F34A8 public buffer pools 0X00211000 public particle pools TOTAL: 0X00396728
If any of the above Memory Requirements are "UNKNOWN", you may be using an unsupported configuration or there is a software problem and system Operation may be compromised. Rounded IOMEM up to: 4Mb. Using 12 percent iomem. [4Mb/32Mb]
Restricted Rights Legend
Use, duplication, or disclosure by the Government is subject to restrictions as set forth in subparagraph (c) of the Commercial Computer Software - Restricted Rights clause at FAR sec. 52.227-19 and subparagraph (c) (1) (ii) of the Rights in Technical Data and Computer Software clause at DFARS sec. 252.227-7013.
cisco Systems, Inc. 170 West Tasman Drive San Jose, California 95134-1706
Cisco Internetwork Operating System Software IOS (tm) C2600 Software (C2600-I-M), Version 12.1(5)T8, RELEASE SOFTWARE (fc1) TAC Support: http://www.cisco.com/cgi-bin/ibld/view.pl?i=support Copyright (c) 1986-2001 by cisco Systems, Inc. Compiled Mon 07-May-01 17:57 by ccai Image text-base: 0x80008088, data-base: 0x80972320
cisco 2610 (MPC860) processor (revision 0x203) with 28672K/4096K bytes of memory . Processor board ID JAD05090M7A (447016375) M860 processor: part number 0, mask 49 Bridging software. X.25 software, Version 3.0.0. 1 Ethernet/IEEE 802.3 interface(s) 2 Serial network interface(s) 32K bytes of non-volatile configuration memory. 8192K bytes of processor board System flash (Read/Write)
Press RETURN to get started!
00:00:12: %LINK-3-UPDOWN: Interface Ethernet0/0, changed state to up 00:00:12: %LINK-3-UPDOWN: Interface Serial0/0, changed state to up 00:00:12: %LINK-3-UPDOWN: Interface Serial0/1, changed state to down 00:00:13: %SYS-5-CONFIG_I: Configured from memory by console 00:00:13: %LINEPROTO-5-UPDOWN: Line protocol on Interface Ethernet0/0, changed s tate to up 00:00:13: %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/0, changed sta te to down 00:00:13: %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/1, changed sta te to down 00:00:14: %LINK-5-CHANGED: Interface Serial0/1, changed state to administrativel y down 00:00:15: %SYS-5-RESTART: System restarted -- Cisco Internetwork Operating System Software IOS (tm) C2600 Software (C2600-I-M), Version 12.1(5)T8, RELEASE SOFTWARE (fc1) TAC Support: http://www.cisco.com/cgi-bin/ibld/view.pl?i=support Copyright (c) 1986-2001 by cisco Systems, Inc. Compiled Mon 07-May-01 17:57 by ccai Cisco2610-003>
